PE100 LU El.Weld End Cap 200 SDR11

This Wavin Monoline electrofusion end cap is used in water and gas systems to close off PE pipes.

In addition to this electrofusion end cap, the electrofusion coupling range includes various accessories, such as:

• Tools.
• Links.
• Welding machines.
• Gaskets.
• Transitions.

Properties

The Monoline end cap has a maximum operating temperature of 20°C with a working pressure of 16 bar for water systems. For gas systems, the maximum operating temperature is 20°C with a working pressure of 10 bar.

Quality mark

The Wavin end cap has Kiwa and Gastec QA certification. This makes the electrofusion fitting suitable for drinking water and gas.

Assembly

This end cap seals a PE pipe. To weld a PE pressure pipe, you'll need a PE cleaner, a peeling device, clamps, and a welding machine. During welding, the coil in the electrofusion attachment heats up, fusing the two components together. This creates a strong, tensile-resistant, gas-tight, and watertight connection.

The welding process

• Place the end cap on the tube and mark the spot with a marker.
• Remove the end cap from the tube, use the peeling device and remove the burrs.
• Clean the area with PE cleaner and, if necessary, re-indicate the length.
• Replace the end cap around the tube and tighten the screws.
• Connect the welding machine, scan the barcode and start the welding process.
• Check the indicator pins, they should have come out all the way.
• Disconnect and remove the welding cables and fixation clamps after the specified cooling time.
• Wait at least 2 hours before pressurizing the piping system.

Want to buy electrofusion couplings or need more information?

The desired electrofusion end cap can be ordered quickly and easily through our website or purchased at one of our locations. Still not sure which electrofusion sleeve is best for your situation? Contact one of our product specialists for free advice.