BONFIX Brass clamp point piece 3/4" male thread x 22 mm

This Bonfix threaded coupling is used for water pipes, gas pipes, heating systems, or industrial transport systems. With a brass compression fitting, you can easily create a safe and leak-free connection between two pipes without welding, soldering, or pressing. The compression fitting can be reused; however, the compression ring must be replaced.

In addition to this wire coupling, the range includes various couplings, such as:

• Clamp ring.
• Knee 90°.
• Support sleeve.
• T-piece 90°.
• Union nut.

Assembly

With a brass compression fitting, you can easily create a strong and reliable connection without any special tools. All you need is a wrench to tighten the fitting, a pipe cutter to cut the pipe to size, and a deburrer to neaten the edges. The compression ring in the fitting ensures a leak-free connection.

• Installing a compression coupling in a water pipe is done as follows:
• Cut the pipe to size and deburr the ends to prevent noisy piping.
• Slide the tube into the compression fitting up to the stop edge.
• Tighten the clamp nut hand-tight.
• Then tighten the compression fitting with a wrench;
• 12 and 15 mm with 1 complete turn.
• 22mm with a half to three-quarter turn.
• 28mm or more with approx. three-quarter turn.

Note: Overtightening the nut can cause leakage. When using soft copper or plastic tubing, we recommend using a support sleeve to prevent pinching.

Want to buy brass compression fittings or need more information?

You can quickly and easily order the compression fitting you need through our website or purchase it at one of our locations. Still unsure which fitting is best for your situation? Contact one of our specialists for free advice.